To begin programming
To program CALL TRACKER
To Program numbers
To program the timer
To end programming
1.
Plug line cord into standard telephone line.
2. Connect transformer to 110V AC.
3. Press and release. Will get deedoodee tone.
1. Press Speak message. Press at end of message.
Will get deedoodee tone. Message maximum length is 18 seconds.
2. Press key to play back the message. Will
get deedoodee tone when done.
If you want to disable press then
Will get deedoodee tone. No message will play
during the phone operation
1. Program first number by pressing followed by the number to
be dialed and then to store the number.
Will get deedoodee tone.
2. Program the second number by pressing followed by the number
to be dialed and then to store the number.
Will get deedoodee tone.
3. If you wish to disable automatic dialing of second number, press
followed by
1. Press followed by again and the time (1-999 miinutes).
Then press to store the time-out. Will get deedoodee tone.
1. Hold until warble sounds, then release. If you get three
low beeps, the key was not held long enough.
Press and hold again until the warble sound.
2. telephone numbers and timer can be independently
reprogrammed at any time.
START
START. STOP
PAUSE CALL TRACKER
NOTE: CALL TRACKER, START STOP.
CALL TRACKER
SET
M1
SET
M2
SET M2.
SET SET
SET
STOP
STOP
CALL TRACKER,
SMARTPHONE II
SIMPLIFIED PROGRAMMING INSTRUCTIONS
POT
D14
GREEN
LED
PHONE LINE
CONNECTOR
TO
TELEPHONE
LINE
TO
110V
AC
SOURCE
6 POSITION
TERMINAL BLOCK
J2
A/C TRANSFORMER
RATH MICROTECH
SUSSEX, WI
1
4
7
0
M1 M2
8
9
5
6
START
STOP
PAUSE
2 3
SET
FAX 12
RATH MICROTECH
Technology of the future, available today!
NOTE:
SMARTPHONE II can
be programmed
without connection
to 110V AC or the
telephone line when
back-up battery is
fully charged.
To Next Page
Need help?
General
