• Installation
• Overview of GD06
Install the display in the middle of handlebar, then adjust to
suitable angle, install the press button to left side of handlebar.
●
Power off the device, connect the device to
controller.
●
Power on
●
1) UART protocol:
Equipped with independent press buttons
2) Speed：
Real-time SPEED
3) kmh/mile：
Kmh/MPH according to habit
4) Battery level：
Indicates the battery level in real time
5) Head light control：
Press button to power on/off
6) Back light adjustment：3-level adjustment
7) Assist level：
From 0 to 5, press button to change assist level, 0-no assist,
5-default value
8) Distance：
ODO/Trip/Driving duration
9)Error code：
Please refer to appendix table 1 for definition
To Next Page
Loading...
