Rauch MDS Series - Page 7

Hopper Cover Assembly
MDS
5900041-b-de/en/fr-0199 7 R.K..
• Bolt on the pivot arm for the hopper cover or hopper covers already equip-
ped with hopper cover extensions to the hopper or hopper extension,as
shown in Dia.7.
• Bolt on the stop (Dia.7, Fig.6) to the pivot arm, using bolt, washer and self-
locking nuts (Dia.7).
Attention: When using hopper cover extensions APE, the cover ex-
tension must be bolted onto the edge of the pivot arm (Dia.6, Fig.8)
(Dia.7, Fig.8). Both stops should now be bolted onto the hopper cover
and pivot arm using the second hole, as shown in Dia.7.
• Now bolt the rod head of the hopper cover to the end of the pivot arm, as
per Dia.8.
• Bolt on stud grips (Dia. 8, Fig.7) to the hopper cover and pivot arm/ rod
head, as per Dia. 8.