Rauch TELIMAT T 1 - Page 21

Assembly Instruction
Telimat T 1
15
• The "U" tube (Fig. 2) is assembled to the frame bracket (Fig. 1) using pivot shaft (Fig.5)
as per diagram 3. Secure in place using washer (Fig.13) and circlip washer (Fig.14)
Diagram 3
• Position the hydraulic cylinder (Fig.3) onto the frame bracket (Fig.1), as shown in dia-
gram 4, and secure in place using washer (Fig.15) and Nut (Fig.8). Pivot the "U" tube
(Fig.2) until the pin (Fig.16), with its head uppermost, can be slid into the piston end yoke.
Connect hydraulic hoses to the tractor control valve and fully extend hydraulic cylinder.
Stop tractor engine and remove the ignition key.
Diagram 4