Ravas 1100 - The weighing Hand Pallet Truck; Taking the system into operation; Power supply

‐4‐
1.TheweighingHandPalletTruck

1.1.Takingthesystemintooperation

Toactivatetheweighingsystem,turnitonusingtheon/off()keyontheterminal.

After3to5minutestheelectronicsandloadcellshavereachedtheoperational
temperature.Beforethis,inaccuraciesofuptoca.0.3%mayoccur.

Itisrecommendednottoliftloadsbeforethezero‐pointcorrectionhasbeenexecuted.

1.2.Powersupply

Thepowersupplytothesystemtakesplacethroughanexchangeablebatterypack.Note:
Forlegalfortradesystemsthepowersupplytothesystemtakesplacethroughafix
mountedbattery.

Withacompletelychargedbatterythetotalweighingtimeisabout35hours(onasystem
withoutaprinter).

Whenthevoltagelevelofthebatteryisrunninglow,thedisplaywillshow .Whenthe
“LO‐BA”indication  isshownfor1or2minutes,theweighingsystemswitchesoff
automatically.Itisstronglyrecommendedtochargetheemptybatterydirectlywiththe
suppliedcharger.

Inordertomaximizethelifetimeofthebattery,followthecharginginstructionsbelow
precisely:
1. Insertthebatteryintothechargermodule.Note:Forlegalfortradesystemsconnect
thechargercabletothesystem
2. Plug‐inthechargeradaptorplug,intomainsvoltage220‐240VDC.TheredLEDonthe
chargeradaptorislittoindicatethatthechargerischargingthebattery.When
charging,itisnecessarytochargethebatteryforatleast6hours.Thiswillprevent
lossofbatterycapacity.
3. Anemptybatterywillbefullychargedafterapproximately6hours.Whenthered
LEDturnsoff,thebatteryisfullycharged.Itisnotpossibletooverloadthebattery
becausethechargerswitchesoffautomatically.
4. De‐connectthechargeradaptorplugfromthe220‐240VDCmainsvoltage.
5. Aftertakingoutthechargeradaptorplug,directlyremovethebatteryfromthe
chargermodule.Note:Forlegalfortradesystemsdirectlyremovethechargingcable
fromthesystemafterremovingtheadapterfromthecharger.
6. Forcharginganextbattery,startatstep1again.
Ifyouusethesysteminshiftworkorifthesystemhasabuilt‐inprinter,itisrecommended
topurchaseasupplementarybatterypack.