CALIBRATE ISO RAVEN STEERING CONTROLLER | CR7 AUTOSTEERING | RAVEN EUROPE GENERIC
PAGE 16/24 | Calibration manual | 016-8000-015EN | Rev. A
Hold the steering wheel on the right and
press the ‘Voltage’ underneath right. The
current voltage is setup as the right voltage
(check if the voltage on right changes to the
current voltage).
Press next step.
Setup the Disengage sensor. First step is to
select the Disengage sensor Type. Press the
box underneath the Disengage type.
When a complete Raven Europe
Autosteering system is installed, a Pressure
Transducer (4 – 20 mA) is mounted.
Select this transducer in the dropdown list.
Make sure this Disengage typ is in the box.
Press next step.
To Next Page
Loading...
Need help?
General
