To get the most out of your new
multifunction jump starter, please read
through these instructions before use. Please
also save the instructions in case you need to
refer to them at a later date.
Jump start current: 200 A
Includes intelligent starter cable
Charging time: approx. 4 hours
Includes 12 V charging cable
With integral LED torch with 3 functions:
constant light, fl ashing and SOS function
The jump starter must be fully charged
The jump starter must only be charged using
the 12 V charging cable or micro USB cable
The jump starter must be charged at least
once every three months, regardless of
whether or not it has been used.
NEVER allow the red and black battery
clamps on the intelligent starter cable to
come into contact with each other, the same
piece of metal or other conductive material.
The current in the battery clamps is
potentially life-threatening! Do not touch the
metal parts inside the clamps.
Do not use the jump starter if the wires in the
starter cable are fully or partially exposed.
If the jump starter falls into water, do not put
Do not touch the jump starter with wet or
damp hands, and do not use in the rain or in
Never expose the jump starter to direct
sunlight, high temperatures or damp.
Do not use in areas where there may be
combustible or explosive fumes, liquids or
To Next Page
Loading...