Check that the starter cable’s clamps are
correctly connected to the car battery. If this
does not solve the problem, the car battery
may be defective, meaning the car cannot be
Press and hold the BOOST button until the
LED displays a steady green light.
Start the car within 30 seconds.
Once the engine has started, you must
disconnect the starter cable’s clamps from
the car battery within 30 seconds. Leave the
Connect the micro USB cable to one of
the USB outputs on the jump starter, and
connect the relevant plug on the multicable
to the device to be charged.
Press the on/off button to start charging. The
jump starter automatically adjusts charging
to suit the connected device.
If the jump starter is fully charged, it has the
capacity to charge a smartphone approx. 3
Press and hold the on/off button for 3
seconds to switch on the LED torch. Press the
on/off button briefl y one or more times to
switch between the LED torch functions:
The jump starter switches off automatically
when it is not being charged, or when power
is not being drawn from it.
Wipe the jump starter with a well-wrung
The jump starter must be stored in a cool, dry
Ensure that the jump starter is recharged at
least once every three months to maintain its
To Next Page
Loading...