rayence 1417WCA - Page 44

40
R-M-014-130312
2nd Step
Push “Get Bright” button at different six of X-ray condition. The X-
ray condition should be set or tested before, same as the level of
‘1.2’. Push “Get Bright” button at least 3 times at same condition,
and then the offset subtracted bright (gain) is generated which of
filename is “xNNNNNA.raw(Refer to NOTE)
Click
button [Get
Bright]. It
will produce frame
with name %CAL%
xNNNNNA.raw,
where NNNNN is
median pixel’s value
within current
image borders after
offset calibration
(cut frame edges are
never used during
calibration). Suffix
‘A’ (it also could be
‘B’,’C’ etc) avoids
casual coincidence
of file names.