Owner manual
the controller case it is needed to remove the three
screws under the frame, just below the battery case.
Contact your nearest distributor or shop and explain the
process done and if the red led was on the controller, they
will give you further instructions.
Scenario 2:
Bike doesn’t turn on and three lights on the throttle
are off, microEIVA installed.
1. Battery not connected:
First of all, take out the battery case of its position. Open it
and check that inside is everything connected and there
aren’t loose connections. After that, close again the case
and place it correctly, ensuring that there is a full contact
between the battery case and the lower pins on the
frame. Lock the battery in the correct position.
2. A blown fuse:
Take out the battery case of its position. Remove both
fuses of the wiring of the battery and inspect them. There
BLOWN FUSE INTACT FUSE
To Next Page
Loading...
