WARNING
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
1
Step 2
Using a 5 mm Allen wrench and a 10 mm wrench,
loosen the two (2) hex bolts on the side of the
battery cover (Figure 2a) and the two (2) locknuts,
located underneath the unit (Figure 2b).
Tools Required: (Not included)
A. 5 mm Allen wrench
B. 10 mm wrench
C. Flathead screwdriver
D. 19 mm wrench
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger
before removing or installing the charger port. Failure to follow these steps in the correct order may
cause irreparable damage.
Step 1
Using a 5 mm Allen wrench, loosen the four (4) hex
bolts that attach the seat to the frame (Figure 1a)
and remove seat. Remove the two (2) hex bolts on
the Drift Bar cover (Figure 1b) and remove.
Figure 1a Figure 1b Figure 2a Figure 2b
CRAZY CART
CHARGER PORT
INSTALLATION INSTRUCTIONS
W25141012106
To Next Page
Need help?
General
Weight and Dimensions
