Step 7
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
2
Step 3
Figure 3
Remove the battery cover by lifting up the right side
first then slide off. Be careful not to pull any of the
wires that are attached to the cover.
Step 4
Figure 4a Figure 4b
Disconnect the black wire from the charger port that is
connected to the top prong of the on/off switch (Figure
4a). Using a flathead screwdriver, carefully remove the
silicone from the back of the charger port (Figure 4b).
Step 5
Figure 5
Using a 19 mm wrench, loosen the locknut.
Step 6
Figure 6
Using a small pointed object, carefully depress the
two (2) locking pins inside the white plastic connector
attached to the charger port and gently pull them out of
the connector. Remove charger port from battery cover.
Reverse steps 1 through 6 to install replacement charger port.
ATTENTION: Charge battery 12 hours before initial use.
140124
To Previous Page
Loading...
