ASSEMBLY AND SET-UP
WARNING:
Failing to properly adjust and
tighten the bolts that affix the
handlebars can cause you to
lose control and crash.
1 Place the handlebars in the
handlebar clamps.
2
Align parallel to the fork and
tighten the bolts using a 6mm
Allen wrench. When properly
tightened, the handlebars should
not move forward or back.
1
Align fender with the hole
in the fork and insert the
bolt. Tighten securely using a
10mm open wrench and 5mm
Allen wrench.
1
Remove screw from front
fork. Align the number plate
with the hole in the fork and
tighten with a Philips screw
driver.
q Attaching the Handlebars MX350 & MX400
Tools required: 6mm Allen wrench
q Attaching the Front Fender
Tools required: 10mm open wrench and 5mm Allen wrench
q Attaching the Number Plate
Tools required: Philips screw driver
To Next Page
Loading...
