Razor E300 Series User Manual

4
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
ASSEMBLY AND SET-UP
Attaching the Seat (E300S Series Only)
Tools required: Two (2) 4 mm Allen wrenches and Phillips screwdriver.
2 Remove the four screws on
the middle of the deck with the 4
mm Allen wrench and the Phillips
screwdriver.
3 Place the seat post on the deck
and secure using the same 4 screws.
1 Attach the seat to the seat post
with two (2) 4mm Allen wrenches.
See note below.
Note: Do not completely tighten at this time. Adjust the seat tilt approximately level to the ground, or slightly tilted
depending on your personal preference. Tighten securely. The seat tilt adjustment should not move when riding.

Razor E300 Series Specifications

General

Max Speed	15 mph
Run Time	Up to 40 minutes of continuous use
Frame	Steel
Grips	Soft rubber
Downtube	Folding
Kickstand	Retractable
Charge Time	12 hours
Handlebar	Adjustable
Battery	24V (two 12V) sealed lead-acid
Motor	250-watt, high-torque, chain-driven motor
Weight Capacity	220 lbs
Tires	9" pneumatic front and rear tires
Throttle	Twist-grip
Brake	Hand-operated, rear
Age	13+
Range	Up to 10 miles (16 km)