To Next PageTo Next Page
Need help?Do you have a question about the Razor EcoSmart Metro and is the answer not in the manual?
General| Max Speed | 18 mph (29 km/h) |
|---|---|
| Range | Up to 12 miles (19 km) |
| Weight Capacity | 220 lbs (100 kg) |
| Motor | 500W high-torque motor |
| Battery | 36V lithium-ion battery |
| Frame | Steel |
| Tires | 16-inch pneumatic tires |
| Brakes | Hand-operated rear disc brake |
| Features | twist-grip throttle, kickstand |
Riding an EcoSmart Metro presents risks, requires caution, and can lead to serious injury or death.
Parental responsibility and supervision are necessary for mature riders aged 16+.
Not for riders under 16 or heavier than 220 lb (100 kg). Ensure rider size is appropriate.
Do not exceed the 220 lb (100 kg) weight limit; rider size must also be appropriate.
Check covers, guards, brake function, tire inflation, and tread before each use.
Activate throttle only when on the scooter in a safe, outdoor riding environment.
Do not attempt stunts or tricks. The scooter is not designed for abuse or misuse.
Never carry passengers or allow more than one person to ride the scooter.
Never ride under the influence of drugs or alcohol. Never hitch a ride with a vehicle.
Always wear approved helmet, elbow pads, and kneepads. Long sleeves and pants recommended.
Wear athletic shoes with laces tied and out of the way of wheels. Never ride barefoot or in sandals.
Regularly inspect charger for damage to cord, plug, or enclosure. Do not use if damaged.
Use only the recommended charger. Battery charging is for adults only.
Failure to heed warnings increases injury risk. Use at your own risk with attention to safe operation.
Ensure the power switch is OFF before any assembly or maintenance.
Do not use non-Razor products. Using aftermarket parts may void the warranty.
Steps for attaching the front wheel using 15 mm wrenches and safety washers.
Steps to plug in the charger, ensure power is off, and monitor charging status.
Check brake function, ensure positive action, no rubbing, and brake cut-off switch.
Always wear approved helmet, pads, long sleeves/pants, and proper shoes.
Steps for starting: turn power on, place hands on handlebars, one foot on deck, push off, apply throttle.
Release throttle and apply brake to stop. Turn power switch OFF after riding.
Check for undercharged battery, faulty charger, or loose wires/connectors.
Check for overloaded motor, reset circuit breaker, or correct overload conditions.
