ASSEMBLY AND SET-UP
3
3 Make certain BOTH handlebars
are properly locked onto the T-bar.
2 Insert and secure the left and
right handlebars by pressing the
spring-loaded buttons and inserting
them into the T-bar.
1 To release the folding mechanism,
place the scooter on the ground,
put one foot on the deck plate and
pull the joint release lever up. Raise
T-bar up until it is securely locked in
the upright position.
1 To adjust the height of the
handlebars, open the quick-release
lever and slide the T-bar to the
desired position and resecure the
quick-release lever to lock into
place. When the T-bar is raised to
the maximum height, depress the
push button located directly below
the quick-release lever to unlock
the T-bar.
Note: The joint release lever is
spring-loaded and will automatically
lock in the upright position when
fully upright.
Note: The tension of the quick-
release lever can be adjusted by
manually tightening or loosening the
Allen bolt. Be careful not to over-
tighten. You should always be able
to open and close the quick-release
lever by hand and the T-bar should
slide freely when the quick-release
is open.
WARNING: Failure to
properly engage the spring-loaded
buttons may cause the handlebars to
dislodge while riding and may cause
you to lose control and fall. When
correctly engaged the handlebars
will not rotate nor will they move
sideways. Note that when properly
engaged, the spring-loaded buttons
are clearly visible in the holes on
the T-bar.
WARNING: Failure to
properly secure the quick-release
lever may cause the T-bar to
telescope up or down while riding
and may cause you to lose control
and fall.
WARNING: Keep fingers
clear of the pivoting mechanism
when folding or unfolding the
scooter. Make sure others are
standing clear.
Unfolding the Scooter for First Time Use
Adjusting the Handlebar Height
To Next Page
Loading...
