Wedge
Safety Zone
Steering Bolt
Throttle
Throttle
4
2 Using a 6 mm Allen wrench, loosen steering bolt in four (4) complete
turns so that the wedge is loose and not touching steering tube.
1 Remove plastic protector at the
end of the steering tube.
4 While inserting the steering tube down into the handlebar tube, hold
steering bolt steady with thumb and rotate handlebars 180 degrees to
the left.
Note: The throttle should now be on your left.
6 Securely tighten bolt using 6 mm
Allen wrench.
3 Facing the front of the Pocket
Mod Bellezza, position the
handlebars so the throttle is on
your right (the red “SAFETY ZONE”
print will be facing you). Align
wedge inside handlebar tube.
5 Slowly slide the handlebars up to
make certain that the bar is in the
“SAFETY ZONE”. Failure to secure
the handlebars within the safety
zone can cause the handlebars to
come out while riding.
WARNING: Periodically
check to make sure the steering bolt
is tightly fastened.
Note: Failure to secure the
handlebars within the safety zone
can cause the handlebars to come
out while riding.
Turn power switch OFF before conducting any maintenance procedures.
Attaching the Handlebars
Tool Required: 6 mm Allen wrench.
Note: Make sure the brake cables/
wires are out of the way before
inserting the handlebar into the fork.
ASSEMBLY AND SET-UP
Steering Bolt
To Next Page
Loading...
Need help?
General