Razor Rift - Setting Up Your Caster Scooter; Installing the T-bar Securely; T-bar Installation Safety Warning

3
SET UP AND USAGE INSTRUCTIONS
q Installing the T-bar
Required Tools: 5 mm Allen wrench
2 With the front wheel
pointed straight ahead and the
handlebars square to the front
wheel, tighten the clamp as
shown. Tighten securely.
1 Using a 5 mm Allen wrench,
loosen the collar clamp and
slide it upward. With a clock-
wise twisting motion, push and
“thread” the T-bar onto the fork
until it bottoms out on the fork
headset lock nut.
WARNING: Failure to
properly install and tighten the
collar clamp may cause the rider
to lose control and fall. If you do
not understand these instructions,
please contact Razor Customer Care
for assistance.