88
USAGE
SEATED RIDING
How to Ride
Make sure the seat is properly installed before seated riding. See pages 6-7 of this manual for seat assembly
instructions. Make sure child is properly seated on scooter, with both hands on the handlebars. Child can start using
their feet to propel themselves forward. A rider must be tall enough to walk the Rollie while sitting comfortably on
the seat, putting both feet flat on the ground.
How to Stop
The rider stops the Rollie by placing both feet on the ground.
How to Operate Deck Lights (Rollie DLX Models only)
• There is no power switch to activate the lights on the deck.
• The deck lights are activated by a vibration sensor.
• Deck lights are activated when scooter is in motion.
• Deck lights will remain on for approximately 20 seconds after scooter has stopped moving. Lights are
re-activated when scooter resumes motion.
How to Operate Wheel Lights
• There is no power switch to activate the lights on the wheels.
• Wheel lights are activated when scooter is in motion.
STAND-UP RIDING
How to Ride
Place one foot on the baseboard and push forward with the other foot. Ride with both hands on the handlebars. To
turn, lean slightly in the desired direction. The “tilt-to-turn” front wheels and axle will cause the scooter to turn.
Practice turning slowly in an open area free of fixed hazards.
How to Stop
For controlled stops, apply the brake by stepping on the rear-fender brake. Razor recommends you practice applying
the brake in an open area free from obstructions before riding your scooter around others.
To Next Page
Loading...
Need help?
General
