Attention : When you adjust the carburetor settings, make adjustments
in very small increments, since the engine is very responsive for small
changes in mixture settings.
GLOWPLUG
There are 2 types of glow plugs available «NORMAL or TURBO» depending
of the type of engine.
Regularly check the condition of the glow plug by taking it out of the engine
and checking the condition of the wire, and when the wire becomes dull or
matt and the engines stalls without reason change the glow plug.
The spiral of the wire should glow a bright orange-white when connecting
the glow plug driver.
If the glow plug wire does not glow, check the battery of the glow plug
driver by testing with a new glow plug. If the glow plug driver cannot make
the wire glow brightly, then replace or recharge the battery.
When possible use only genuine RB Concept glow plugs, since these
have been extensively tested and approved for the maximum performance
of our engines
When the glow plug wire is broken, melted or missing, this is not a good
sign, and so it is advised to check your engine entirely for damage before
you continue using it.
A broken glow plug wire or the complete disappearance of the wire is
usually caused by running the engine too lean, so we suggest that you
richen the main-needle setting after you have experienced a glow plug
failure, and suggest that you avoid this if you want your engine to last.
Standard plug
Turbo plug
www.rbproducts.com Page 7 instruction manual
To Next Page
Loading...