8 / 28
Pull & rotate the
toolto wrap.
While rotating the
tool with the other
hand pull the
loose side of the
cable to keep the
cable tight on the
fence.
Wrap the wire around
both the sensor cable
and fence.
Slidethe hook inside
the rings.
• Attach ties every 12 inches / 30 cm. Only place ties
vertically.
• Although we strongly recommend the use of
IRONCLAD ties due to the extended durability of
metal versus plastic, installation can also be done with
any outdoor UV plastic tie wraps/zip ties.
Be prepared to replace non-IRONCLAD ties
periodically. DO NOT use white zip ties.
• Ties must be securely tightened to prevent the
cable from sliding within the tie loop.
Do not over-tighten ties on the cable.
1
2
3
Sensor Cable Installation On The Fence
4
5
Wire appearance
and position
when wrapped.
Wrapped wire
should remain
within fence as
shown.
To Next Page
Loading...