Using Automatic Code Search
The following instructions can be used to program the remote to operate each of
your componer_ts. If you want to stop the automat[(" (:ode search without
programming any of your eomponents, press (}LEAR until the indicator on the
remote turns off.
1. Turn on the component you want to operate (VCR or DVD player)
2. Pless and hold the eomponent button you want to program (V(}R ol DVD}.
While holding the component button, press and hold ON,OFF until the
indicator on the remote turns on, then release both buttons.
3. Point the remote at the component. Press and release PLAY (the indicator light
on the remote flashes).
The remote is seal('l'_in9 for the conect code to program. When the [ndk'ator
stops flashing (after about 5 seconds), press PLAY again to tell the remote to
sealeh the next set of codes.
Corlt[nue pressing PLAY until the component turns off or the ind[eatol light on
the remote turns off. If the indicator light turns off, then all the codes fol that
partieulal component have been tested once. If the component does not turn
off, then the remote can't be programmed to operate that component.
Note: EachHmeyou pressPIAY,theremotesendsabout 10setsof codes Therefore,you
might haveto pressthe PLAYbutton up to 20 times
If the component you want to operate does turn off:
1. Press and release REVERSE,then waft 2 seconds. Repeat this step until the
device turns back ON.
2. To finish, press and hold STOP until the indicator on the remote turns off.
Using Direct Entry
1. Turn on the component to be programmed.
2. Look up the bland and ('ode number(s) for the component on the ('ode list [n
this section.
3. Press and hold the component button you want to program on the remote.
4. Enter the ('ode from the remote control ('ode list on the following pages. If the
indicator flashes, you have either entered an invalid ('ode or the button isn't
programmable.
5. Release the component button.
6. Point the remote at the component. Press ON,OFF to see if the eomponent
responds to the command. If it doesn't, try pressing the component button and
then ON.OFF again.
o If you get no response, repeat these steps using the next code listed fol your
brand, until the component responds to the remote commands.
If you try all the ('odes for your component brand and none work, try the
automat[(: ('ode seaK'h method. If automatic ('ode sealch doesn't find the ('ode,
the remote [s not compatible with your component.
Chapter 2 Graphics contoined within this publication _lre for representation only 11
To Next Page
Loading...
Need help?
Picture
Weight and Dimensions
