RCA ANT115

Viewing Mediacom cable channels
1. To view cable channels, press the “B” button on the A/B Switch.
2. Tune TV channel to 3 (some areas use channel 4).
3. Use TV remote control to tune in the desired cable channel.
C. Installing TV with multiple RF input ports and set-top-box
1. If coaxial cable from set-top box is connected to the “VHF/UHF” RF input on the TV,
unscrew and move to “AUX” RF input port. Tune TV channel to 3 (some areas use
channel 4). If video and audio cables are used to connect the set-top box to the TV,
leave cables in place, skip this step and go to step 2.
2. Connect the RCA ANT115 Indoor Antenna coaxial connector to the VHF/UHF RF
input of your TV set.
Caution: All F-connectors must be finger tightened
!
VIDEO IN
CATV INPUT FROM
AUX
Viewing VHF/UHF off-air stations
1. To view VHF/UHF off-air stations, use the TV remote control’s “AUX/ANTENNA”
button to select and set TV to “VHF/UHF” mode.
2. Use the TV remote control to select the desired off-air station.
Note: Before viewing off-air VHF/UHF stations you may need to auto program the
received channels. (See your TV owner’s manual for instructions.)
Viewing Mediacom cable channels
1. To view cable channels, press the “AUX/ANTENNA” button on your TV remote
control and change input to the “AUX” mode.
Note: If video and audio cables are used to connect the set-top box to the TV, change to
“INPUT 1 or 2” mode.
2. Tune TV channel to 3 (some areas use channel 4).
VHF/UHF
TO
CONVERTER
1
2
S VIDEO
VIDEO
AUDIO
L
R
VHF/UHF ANTENNA
SET-TOP-BOX
TV SET
3