EasyManua.ls Logo

RCA ANT115

RCA ANT115
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
VHF/UHF Antenna Installation
Getting Started
Installation kit contents:
A/B Switch
o two screws
o one double-sided tape
Coaxial cable jumper with F-connectors
RCA ANT115 Indoor Antenna with instructions
Unpacking and setting up RCA ANT115 Indoor Antenna
1. Remove the RCA ANT115 Indoor Antenna and instructions from package.
2. Install the retractable VHF dipole and UHF loop antenna as shown in Steps 1 and 2.
Note: Do not complete Step 3 listed on RCA ANT115 Indoor Antenna instructions
sheet.
3. The A/B Switch can be mounted by using the double sided tape or screws.
4. Choose the most appropriate configuration from following installations A, B C or D.
A. Installing TV with one RF input port and no set-top-box
1.
Connect the RCA ANT115 coaxial cable F-connector to the A/B Switch “CABLE A”
port.
2. Disconnect the coaxial cable connected to the TV set “VHF/UHF” input RF port
(some older sets may be marked with “Cable or Antenna”) and connect it to the A/B
Switch “CABLE B” port.
3. Connect one end of the coaxial cable jumper to the A/B Switch “TV” port.
4. Connect other end of the coaxial cable jumper to the TV set “VHF/UHF” RF input
port.
Caution: All F-connectors must be finger tightened
!
CABLE B
CABLE A TV
A B
CABLE B
CABLE A TV
AA BB
A/B SWITCH
TV SET
VHF/UHF
VIDEO
AUDIO
INPUT
R
L
VHF/UHF
VIDEO
AUDIO
INPUT
R
L
VHF/UHF ANTENNA
CATV INPUT
LL FROM WA
OUTLET
Question and Answer IconNeed help?

Do you have a question about the RCA ANT115 and is the answer not in the manual?

RCA ANT115 Specifications

General IconGeneral
BrandRCA
ModelANT115
CategoryAntenna
LanguageEnglish

Summary

Getting Started

Unpacking and Setting Up RCA Antenna

Instructions for unpacking and assembling the RCA ANT115 indoor antenna.

Installing TV with One RF Input and No Set-Top Box

Connecting Antenna to TV Without Set-Top Box

Connects the RCA ANT115 antenna and coaxial cable to a TV's single RF input.

Viewing VHFUHF Off-Air Stations

Instructions for tuning into off-air VHF/UHF channels using the A/B switch.

Viewing Cable Channels

Instructions for tuning into cable channels via the A/B switch.

Installing TV with One RF Input and Set-Top Box

Connecting Antenna to TV With Set-Top Box

Connects the RCA ANT115 antenna to a TV with a set-top box via A/B switch.

Viewing VHFUHF Off-Air Stations

Instructions for viewing off-air stations with a set-top box setup.

Viewing Cable Channels

Instructions for viewing cable channels with a set-top box setup.

Installing TV with Multiple RF Input Ports and Set-Top Box

Connecting Antenna to TV with Multiple Inputs

Connects antenna to TV with multiple RF inputs and a set-top box.

Viewing VHFUHF Off-Air Stations

Instructions for viewing off-air stations on TVs with multiple inputs.

Viewing Cable Channels

Instructions for viewing cable channels on TVs with multiple inputs.

Installing High Definition TV (HDTV) and Set-Top Box

Connecting Antenna to HDTV

Connects the RCA ANT115 antenna coaxial connector to the HDTV's VHF/UHF RF input.

Viewing VHFUHF Off-Air Stations

Instructions for viewing off-air stations on an HDTV.

Viewing Cable Channels

Instructions for viewing cable channels on an HDTV.

Related product manuals