To Next Page

To Previous Page

English

4. Remove the black liner for each strip.

5. Line up the antenna where you want to put it, then press it against the wall for 10

seconds.

6. Stop pressing the antenna against the wall and conﬁrm that it’s ﬁrmly attached to the

wall. Then press an additional 30 seconds.

Important: The mounting strips have tabs that extend beyond the borders of the adhesive. Leave

these in place--they will allow you to remove the antenna without damaging your wall.

Questions and Answers:

Need help?

Do you have a question about the RCA ANT1150F and is the answer not in the manual?

RCA ANT1150F Specifications

General