DO NOT RETURN this product to the store! Visit
RCAAntennaHelp.com for instructional and how-to videos.
Unplug the antenna amplier and make
sure your TV is turned off.
Connect the coaxial cable from the
antenna amplier to the antenna input on
your TV or digital converter box.
Important: Make sure you uncoil the
antenna’s cable completely. Leaving it
coiled will reduce reception performance.
Most TVs have a channel scan option in their menu system, many times in a
SETUP or CHANNEL menu under ANTENNA.
For detailed instructions on performing a channel scan, see the owner’s
manual that came with your TV.
Important: You must perform a channel scan to receive any channels!
STOP!
Plug the antenna amplier’s power adapter into a
standard AC outlet. Don’t connect it to your TV yet.
Important: This power adapter should be plugged in so
that it stays vertical or lays at.
There are two easy ways to mount the antenna.
Option 1: Using the mounting squares
Separate the
mounting
squares (there
are four in the
box).
For each square,
remove the
backing and
press the square
into place on the
antenna.
Remove the liner
from the other
side of each
square.
Line up the
antenna and
press it against
the mounting
surface for 10
seconds. Let go,
then press 30
seconds more.
Option 2: Using the antenna’s mounting holes
Insert two thumbtacks (not included) into
the two holes on the top of the antenna.
Connect the antenna to your TV.
3
Mount the antenna.
5
Scan for channels on your TV.
6
Use the antenna’s signal meter to ne-tune
antenna location and orientation.
2
Check out setup videos at
www.RCAAntennaHelp.com
ANT3ME QSG 02
Versión
en español
al dorso
amplied indoor HDTV antenna
with signal meter
QUICK START GUIDE
Use the RCA Signal Finder App to nd the
best location for your antenna.
1
Antenna Placement Tips
Avoid metal surfaces (like a metal stand).
Move the antenna close to or in a window.
Position the antenna as high as possible.
In the Google Play or Apple App Stores, search for “RCA Signal
Finder” and look for the icon shown here. Then download and
install the App.
Launch the App and follow the directions there to nd the
best location and orientation for your antenna.
The signal meter on
the antenna’s amplier
measures the signal of the
strongest UHF signal your
antenna is receiving.
Move your antenna until the
signal meter shows at least
the middle yellow indicator.
For best performance, try to
get the green!
Plug in the amplier.
4
Plug the antenna amplier’s power adapter into a
standard AC outlet.
Important: This power adapter should be plugged
in so that it stays vertical or lays at.
To Next Page
Need help?
General
