Optional RCA DC Car Cord Adapter
The optional RCA DCC08 DC car cord
shown on page 2 allows you to power
your camcorder from the cigarette lighter
socket of a car, truck, or RV. It converts
12-volts to a 6-volt output.
Note: Consult the installation and operating
instructions enclosed with the DCC08 for
complete operating instructions.
used only with vehicles having negative
ground electrical systems.
Use only RCA car cord adapte_vDCC08
with this camcorder. Use of any other
car cord adapter may damage the
eamcorder and void your warranty.
Using the RCA DCC08 DC Car Cord Adapter
Power Switch - -- "_
Cigarette
Lighter Socket Power
Indicator
_ __"' P°we_l____
Optional DCC08 Car Cord Adapter
1. Slide the POWER switch to turn off
the camcorder. POWER indicator
turns off.
2. If the battery is attached to the
camcorder, remove it.
3. Hold the power connector flush against
the back of the camcorder and slide it
to the right in the direction of the
arrow as shown.
4. Take the vehicle's cigarette lighter out
of the socket.
5. Insert the car cord's cigarette lighter
plug into the vehicle's cigarette lighter
socket. The POWER indicator on the
car cord adapter will light.
6. Slide the POWER switch to turn on the
camcorder. POWER indicator turns on.
Caution: Make sure the camcorder's
power is turned off before removing the
car cord's plug from the Cigarette lighter
socket.
20
To Next Page
Loading...
Need help?
General
