Theapproximatetimeremainingonthetapeinthecamcorderisautomatically
displayedintheviewfinder.TheTC-20/TC-30 switch must be set to the correct
position before the camcorder can correctly calculate time remaining.
CA MERA/PLA Y
Switch in CAMERA
Time-Remaining Display
TAPE END 90MIN
Display in Viewfinder
--90MIN
l
89MIN
i
I
I
'4'
3MIN
1
2MIN
(Flashing)
l
1MIN
(Flashing)
OMIN
(Flashing)
Set the TC.20/TC30 Switch
Before recording, set the TC-20/TC-30
switch for the size of tape you are using.
• Select TC-20 when using a tape with
20-minutes or less recording time
when using SP recording speed.
• Select TC-30 when using a tape with
more than 20-minutes recording time
using SP recording speed.
Note: The time-remaining display does not
work for TC-40 tapes.
The time-remaining indicator will start
flashing when the remaining tape time
reaches two minutes.
TAPE END appears when the tape
reaches its end during recording or when
a cassette is loaded whose tape is already
at its end.
45
To Next Page
Loading...
Need help?
General
