6
Base Unit Set-Up
Where to Use.
Use in the room where the DBS
Receiver is located.
How to Set-Up
1. Plug the Base Unit power cord into standard
electrical outlet.
2. Point the front of the Unit (logo side) facing
the DBS Receiver. Extend the antenna
for best performance.
3. Check the following distances
• Base Unit is within 20 ft. of DBS Receiver.
• Base Unit is within 100 ft. of Extension Unit.
Maximum 20 FT.
After setting up your Extension and Base Units, operate the Signal
Sender by aiming your remote at the RCA logo on the front of the
Extension Unit.
To Next Page
Loading...
Need help?
General
