RCA J22H760

35Chapter 3
Chapter 3: Using USB Clone Tool
USB Cloner Operation
1. USB Connector
Connects to the USB port of the TV or PC.
2. Service Port
Connects to the service port of the television. See “Learning” section for details.
3. Mode Switch
Mode Selection Switch.
4. Status LED
Shows the status of the USB Clone.
5. Learn Button
Button to start the “learn” process. See “learning” section for details.
1
4
5
2
3
Teaching
Learning
Errors Table
Flashing Red/Green LED indicates the following error conditions.
Error Detected in TV Channel list file.
Error in transmission Data Packet
No response from service port.
Couldn’t save TV settings to USB Cloner
1
2
3
4
4
5
6
10
Number of Green
LED Flashes