THE DISPLAY
1. Random Playback
2. ESP• XTREME - 180 sec ESP
ESP - 45 sec ESP
3. Is displayed when Bass Boost is ON.
Press Bass Boost momentarily to
toggle between Bass Boost 1, Bass
Boost 2 and off.
4. Program mode
5. Repeat entire disc or repeat current
track.
6. Is displayed when the control button is
on HOLD position.
7 Battery Indicator.
Listening to a Compact Disc
Slide the open switch to the right to
open the door. Insert a disc and press
lightly on the centre to lock. Close the
door.
Playback
Press Play/Pause button on the main
unit or Play/Stop on the remote con-
trol to start playback.
Rd DISC will appear in the display. Then,
the total number of tracks and time of
the CD will be displayed. If the disc com-
partment is empty or the disc cannot be
played, No Disc will appear in the display.
The ELECTRONIC SHOCK PROTECTION*
system prevents sound interruptions
when impacts or vibrations occur.
Electronic anti-shock consumes less power
and increases the battery life. Therefore,
the ESP function is always ON.
After many successive impacts, the buffer
might be emptied causing a brief sound
interruption for the memory to reload.
ESP•XTREME (180 seconds buffer) -
Press Play/Pause on the main unit or
Play/Stop on the remote control to
power on the unit. The display will show
180 sec.
ESP (45 seconds buffer) - For better lis-
tening quality, press prog•display while
pressing Play/Pause to turn the unit
on. The display will show 45 sec.
THE CD PLAYER
AC Outlet Power Supply
(supplied with LAD888U / LAD888WU / LAD898U
only)
You can power your CD player with an
AC/DC adaptor. Refer to the table for
details of the operating voltage.
AC/DC adaptor is purposed for indoor use
in dry rooms only. Remove the jack from
the device to use it with the batteries.
Note : Power is fed to the unit even
when it is not functioning. To cut the
power supply off, the AC/DC adaptor
must be unplugged.
Car (DC) Power Supply
Adaptor (For RP2445 / RP2447 only)
Plug the car (DC) power supply adaptor
into the DC in 4.5V jack at the rear/side of
the CD player & then into the cigarette
lighter receptacle in your car
Battery Power Supply
Refer to the table for details of the
batteries required to operate your unit.
Recharge function (For LAD888U /
LAD888WU / LAD898U only)
To charge Ni-Cd batteries:
1. Insert 2 rechargeable batteries into
the battery compartment on the main
unit.
2. Connect the main adaptor.
3. Press STOP on the unit to start
recharging. An animated battery indica-
tor will be displayed when recharging is
in progress.
THE CD PLAYER
Model Number
RP2441 / RP2442 /
RP2443 / RP2444 /
RP2445 / RP2447
LAD888U / LAD888WU/
LAD898U
AC/DC Adaptor
5-4079B
(not included)
Required Rating:
Input: 120VAC 60Hz 6.0W
Output: 4.5VDC @ 600mA
5-4090A
(Included)
(230V 50Hz)
Batteries
AAx2
(Not Included)
2 x 1.5V IEC R6 (UM3)
(Included)
AAx2
(Included)
Power Supply
To Next Page
