EasyManua.ls Logo

RCA LGB146

RCA LGB146
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CAREAND CLEANING
?%
,f-
L* *
per care and cleaning are important so your range
BE SURE ELECTRICAL POWER IS
‘will
give you efllcient and satisfactory service. Follow
DISCONNECTED BEFORE CLEANING ANY
these directions carefully in caring for it to help assure
PART OF YOUR RANGE.
safe and proper maintenance.
I
CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS
(IF SO EQUIPPED) IN PLACE.
I
Sdd Burner Assemblies (on some models)
~G~te
Burner Cap
Drip Pan
(on some models)
L!!!!iF::::d
‘lhrn all controlsOFF beforeremovingthe
burnerpartsand drip pans (if so equipped).
e
e burner- ca~ burnerheadsanddrip
(if so equipped)can be liftedoff, makingthem
easy to clean.
The electrode of
the
spark igniter is
exposed when the
burner head is
[@+/Ebftrode
removed.When one
burner is turned to LITE, all the burners spark.
Do not attempt to disassemble or clean around
any burner while another burner is on. An electric
shock may resul~ which could cause you to knock
over hot cookware.
Burner Heads (on sealed burners OnIY)
For proper ignitio~ make sure the small hole in
the section that fits over the electrode is kept open. A
sewing needle or wire twist-tie works well to unclog it.
The slits in the burner heads of your range
must be kept clean at all times for an even,
unhampered flame.
You should clean the surfaceburnersroutinely,
especially afterbad spillovers, which could clog
these openings.
To remove burned-on food, soak theburnerheads
in a solution of mild liquid detergentand hot water
for 20-30 minutes. For more stubborn stains, use a
toothbrush.
Before
puttingthe burnerheadback, shakeout
excess water and then dry it thoroughly by setting
it in a warm oven for 30 minutes.
Replace the burnercaps. Make surethat
caps are
replacedon the correctsize burner.Thereis one
small, 2 medium andone largecap.
Burner (bps (on sealed burners only)
Liftoff when cool. W@hburner caps
in h@ soapy water and rinse with
clean water. You may scour with a
plastic scouring pad to remove
burned-on fd particles.
Dry
them in a warm oven or with a
cloth-don’t reassemble them wet.
e
eplace the burner caps.
‘Make sure that caps are replaced on
the correct size burner. Them is one
small, 2 mediumandone huge cap.
medium
a %s”’”
‘e”uml@@+’a”e
I
1
.
Front of Range
(continued next page)
21
————.— ---