du
%
Situations where Appliance
‘ower rd will be Diwxmnected Infkequentiy.
n adapter maybe used only on a M-amp
tit Do not use an adapter on a 20-amp
ircuit Where local codes permit a
EMPORARY CONNECI’ION may be
~de to a properly grounded two-prong wall
~ceptacleby the use of a ULlisted adapter,
milable at most hardware stores. The larger
lotin the adapter must be aligned with the
wgerslot in the wall receptacle to provide
---
roper polarity in the
ower cord.
EIWORARY
METHOD
Adapter plugs not
wmittad in Canada)
Align large
prongs/slats
comection ofthe
&
Q
Ii
@
,
<&:-“ -A ,
3
/
0-’
Ensure proper
ground and
CAUTION:Attaching the adapter ground
terminal to the wall receptacle cover screw
does not ground the appliance unless the cover
screw is me@ and not insulated, and the wall
receptacle is grounded throu h the house
%
m. ‘I”hecustomer should ave the circuit
checked by a qualifiedelectrician to make sure
the receptacle is properly grounded.
Vhendiscom “
7
the power cord from t-he
dapter, always ho the adapter with one hand.
fthis is not done, the adapter ground terminal
svery likely to break with raeated use. Should
his h~ppenj
DO N(YI’USE &e appliance until a
~roperground has again been established.
❑ Usage Situation. where Appliance Power
Cord will be Disconnected Frequently.
Do not use an adapter plug in these situations
because disconnecting ofthe power cord
places undue strain on the adapter and leads to
eventual fidlure ofthe adapter ground terminal.
The customer should have the two-prong
wall receptacle replaced with a threeprong
&rounding) receptacle by a qualified electrician
before using the appliance.
The installation of appliances designed for
mobile home installation must conform with
the Manufactured Home Construction and
Safety Standard, Tkle 24 Cm Part 3280
(formerly the Federal Standard for Mobile
Home Construction and Safety,Title 24, HUD,
Part 280) or, when such standard is not
applicable, the Standard for Manufactured
Home Installations, latest edition (Manufactured
Home Sites, Communities and Set-Ups),ANSI
A225.1,latest edition, or with local codes. In
Canad~ mobile home installation must be in
accordance with the current CAN/CSA
Z240/MH Mobile Home Installation Code.
EIWtricO&OmWt
1. Locatedisconnectplug on the range back.
2. Pinch sides of connector and pull out of
range back.
Yoawillbavothii dkomoct pi-
(continued next page)
33
—.
——--—. ----
To Next Page
Loading...