❑ COH’VERTM6SURFACEBURNERS
1. LiftCooktop.
2. Uft burner assemblies straight up and set
aside to gain access to surfiwe burner spuds.
\
3. With a 7mm, 5/16” or small adjustable
wrench, remove each ofthe four spuds on the
surfiwe burner gas inlet tubes and replace them
with the correct gas spuds mounted in a holder
at the right rear ofthe range, above the
regulator. Natural gas spuds are brass and LP
gas spuds are red or silver. (Mount the spuds
that you removed horn the inlet tubes back in the
holder.)To prevent leakage, make sure spuds are
securely screwed into gas inlet tubes.
4. Replace the burner assemblies.
5. Keep all spuds with your range so you have
them ifyou move or get a different gas hook-up.
Top Burner
Orifice Drill
size Color
Natural Gas
#54 (.0550Dia.)
Brass
IX (Propane)
#66 (.0330Dia.)
Red or Siver
42
❑ ADJUST OVENTHERMOSTAT
(for Models Equipped with Standing Pflots)
1. Remove the oven
control knob.
20 Locate the thermostat
adjustment screw at left of
thermostat shatt Turn the
screw until the small
pointer stops at LP or N,
depending on the type ofgas
you are converting to. The most
~,1 sc~cwill move is
3. Replac~ the OVEN CONTROLknob.
—
_———.—..—..—..
To Next Page
Loading...