Installation
(
3
1
Disconnect the VHF antenna from your TV.
0
2 Attach one end of the coaxial RF cable to the
Connect the antenna to the
VHF
IN connector on
VHF OUT
connector on the RF output adapter
the optional CRF800 RF output adapter if you
and the other end to the VHF input on your TV.
leave the adapter connected to the TV.
Note: If your TV has screw terminals, you may need
Note: If your VHF antenna is the flat twin-lead type
an optional 75-300 ohm transformer, such as
AH01
1.
attached by two screws, you will need an optional
0
3
300-75 ohm transformer, such as 193983.
Attach the RF output adapter’s plug to the
output jacks located behind the door on the side
of the camcorder.
Playback Operation
Set CHANNEL
4CH/3CH
switch on the RF
output adapter to
4CH
or
3CH.
Turn on the TV, and tune it to channel 3 or 4
-
whichever channel you selected with the
CHANNEL
4CH/3CH
switch.
Attach a power supply, and press and hold the
small button on the camcorder’s POWER switch
while you place it in PLAY.
Viewing What the Camcorder Is Recording
Turn on the TV and tune it to channel 3 or 4.
Note: When the camcorder is used as a camera, turn
the TV’s volume down to prevent a high-pitched
squeal caused by feedback.
Set CHANNEL switch on the RF output adapter
to the same channel you selected on the TV.
Attach a power supply and press and hold the
small button while you slide the camcorder’s
4.
5.
Normal TV Viewing
You can leave the RF output adapter hooked up
to the TV. Disconnect the adapter’s plug from
the camcorder or turn off the camcorder’s power.
Insert the cassette you want to play back.
Press PLAY to begin playback.
l
During playback, use the playback features
descriherl
ofi
pgc
33.
Press STOP when you are finished.
POWER switch to CAM. Make sure ON/POWER
SAVE is ON.
Insert the cassette you want to record on.
Press the thumb trigger on the camcorder
(START/STOP on remote) to start recording. You
can watch what you are recording on the TV
screen.
37
To Next Page
Loading...
Need help?
General
