RCA RCRV06GR User Manual

9
English
3. Say “TV Power” again.
If the two words match, the RCA Voice
Control Remote responds: “Press the
buttons you want to use for this voice
command. Press TRAIN to finish.”
“Press the
buttons...”
“B utt on acc ept ed.
Pu sh ano the r
bu tto n”
TV
power.
4. Press the TV button. (The remote
waits 15 seconds for you to press each
button in the command.)
The RCA Voice Control Remote
responds: “Button accepted. Push
another button.”
5. Press the POWER button.
The RCA Voice Control Remote
responds: “Button accepted. Push
another button.”
1. Say: “Remote control.” The
COMMAND light illuminates.
2. Say: “TV Power.”
The remote automatically sends the TV
and POWER commands. Your TV turns
on.
IMPORTANT: Once you have trained a voice command the
pre-programmed commands will be disabled. If you would like
to train your own keyword (other than “remote control”), see
page 12 for more instructions.
To use your “TV Power” command:
Note: If the KEYWORD light is off, press the LISTEN button rst.
“Voice
command
assigned.”
“B utt on acc ept ed.
Pu sh ano the r
bu tto n”
Remote
control.
TV
power.
6. Press the TRAIN button to complete
the command.
The RCA Voice Control Remote
responds: “Voice command assigned.”
The voice-command “TV Power” is now
assigned to the multi-step sequence TV
and POWER.

RCA RCRV06GR Specifications

General

Brand	RCA
Model	RCRV06GR
Category	Remote Control
Language	English