10
PROGRAMMING THE SLEEP TIMER
1. Press and hold the SLEEP key
until the indicator light illuminates.
Release the SLEEP key.
2. Enter time in minutes using the
numerical key pad. The indicator
light should turn off. (Minute 1 thru
9: press 0 before the actual number.
Maximum: 99 minutes).
3. Leave remote aimed at television.
(IMPORTANT: The Sleep Feature will
not work unless remote is left aimed
at television).
CANCELING THE SLEEP TIMER
The Sleep Timer program can be
canceled and reset to zero by either
of the following:
1. Press and hold the SLEEP key
until the indicator light blinks.
OR
2. Press the POWER key, turning TV off.
The Sleep feature turns off your TV automatically at a
duration you choose from 1 to 99 minutes. To program
your remote to control the Sleep feature, follow these steps:
Sleep Feature
INDICATOR
LIGHT
(BLINK)
SLEEP
SLEEP
This remote cannot access every menu system of all models
and brands of consumer electronics components. However,
if you’ve successfully programmed the VCR•DVD key to
operate a DVD player, you can access DVD disc menus with
the MENU key.
The MENU key will also access TV menu systems for
most RCA, GE and PROSCAN TVs, as well as some other
popular brands. Also, some RCA VCR menus are supported
by this remote’s MENU key. This remote also supports
select satellite receiver menus.
If this remote’s MENU key doesn’t access the menu system
for your component, you’ll need to use the original remote
to change menu settings.
Note: This remote’s MENU key doesn’t support cable box
menu systems and some VCR menu systems.
On-screen Menus
OR
To Next Page
Loading...
Need help?
General
