7
Program for DBS (Satellite) or
Cable Box—Direct Entry Method
DBS•
CABLE
1. Manually turn on the DBS or Cable
Box system.
2. Locate the enclosed DBS or Cable
Box Code List. Find your brand in
the DBS Cable Box Codes.
Note: If your brand isn’t listed, use
one of the Code Search methods to
program this remote control. (See
section on Code Search on page 8).
3. Press and hold the CODE SEARCH
key until the indicator light
illuminates. Then release the
CODE SEARCH key.
4. Press and release the DBS•CABLE
key. The indicator light blinks and
then remains lit.
5. Use the number keys on the remote
to enter the first code listed for your
brand. After you enter a valid three-
digit code, the indicator light turns off.
Note: If you enter an invalid code, the
LED flashes rapidly for two seconds.
Start over at step 3.
6. Aim the remote at the DBS or Cable
Box system. Press the POWER key.
If your DBS or Cable Box system turns
off, you have found the correct code.
7. If your DBS or Cable Box system does
not turn off, repeat steps 3-6 above,
entering the next code for your brand.
If none of the codes work or your
brand is not listed, use one of the
Code Search methods to program this
remote. (See Code Search section on
page 8).
8. Enter the code in the box provided
on this page for future reference.
In order for the three-component universal remote to control
your DBS or Cable Box system, you must program it with
the code that matches your component. Most RCA, GE and
PROSCAN components do not require programming. Check
to see if your DBS or Cable Box system responds to the
remote before you begin programming. To program your
remote to control your DBS or Cable Box system, follow
these steps:
To Next Page
Loading...
Need help?
General
