Turn the VCR On and Off.
1. Press VCR1
or
VCR2•LD to set the remote
to control the VCR.
(Most RCA, GE and
ProScan models will only turn on when
pressing VCR not POWER).
2. Press POWER to turn the VCR on or off.
Using the VCR function buttons.
1. Turn on the VCR.
2. Insert a tape in the VCR.
3. Press PLAY to start the tape.
4. Press STOP when you are finished.
5. Press REW to rewind the tape.
6. Press PAUSE to pause the tape.
Record one channel and watch another.
1. Press VCR1
or
VCR2•LD to set the remote
to control the VCR.
2. Tune the VCR to the channel you want to
record.
3. Press REC to start recording.
4. Press TV/VCR.
5. Press TV to set the remote to control the TV.
6. Press CHANNEL UP or DOWN to
change channels on the TV.
7. To see the channel you are recording,
tune the TV to channel 3 or 4 (same as CH3/4
switch on the VCR). Tune to 90, 91, or 92 for
some RCA, GE or ProScan products.
Operating Your VCR
8
To Next Page
Loading...
Need help?
General
