4
0-9 (Number Keys): operate the same
as number keys on your original
remote and are used to enter
component codes when
programming the remote control
with Direct Entry method.
ANTENNA: in TV Mode, switches
between the signal coming from a
satellite receiver or cable box and an
off-air antenna. In VCR Mode,
switches between the signal coming
from a VCR and a TV.
CH+ and CH- (CHANNEL UP and
CHANNEL DOWN): goes to the next
highest or lowest channel number
in the component channel list,
respectively, except for DVDs. In
DVDs, the CH+ and CH- keys refers
to the NEXT/PREVIOUS chapter.
CLEAR: removes the on-screen
display to return to normal viewing.
CODE SEARCH: use to program
the remote.
ENTER: use with Manual or
Automatic Code Search method to
accept code (See Code Lists enclosed).
Also, some brands require you to
press the ENTER key after you enter
a channel number. In some menu
systems, you must press the ENTER
key to select a highlighted item.
GO BACK: switches back to previous
channel– operates the same as PREV CH,
LAST CHANNEL or RECALL keys
found on some brands of remote controls.
GUIDE: brings up the on-screen TV
program guide, if your TV is
equipped with that feature.
INFO: shows program information,
if your component is equipped with
this feature. Functions the same as a
DISPLAY key.
Primary Key Descriptions For VIDEO Operations
Other Keys (Listed Alphabetically)
Certain keys on the six-component universal remote have dual functions.
Primary functions are printed in black. Secondary key functions are printed
in blue on the remote and are used for AUDIO operations.
INPUT: selects the video inputs of your TV, if equipped with this feature.
MENU•PROG: accesses DVD disc menus when playing a DVD disc. Accesses
menu systems of some TVs, a few RCA brand VCRs and satellite receivers.
(For more information, refer to the On-screen Menus section on page 12).
MUTE: lowers the TV’s volume to its minimum level.
NAVIGATION KEYS & SELECT: used to move through on-screen menus and
guides. Use the NAVIGATION keys to move the highlighted choice up, down,
left or right.
ON•OFF: turns component on and off.
Note: Some RCA, GE and PROSCAN models require that you press the
component key to turn the component on and the ON•OFF key to turn the
component off.
PIP: (Picture-in-Picture) and SWAP operate your TV’s Picture-in-Picture,
if your TV is equipped with this feature.
RECORD: use with VCR to record programming. You must press the
RECORD key twice
to start recording.
SLEEP: allows you to set a time to turn off your TV automatically.
VOL: increases or decreases the TV or AUDIO system’s volume level.
To Next Page
Loading...
Need help?
General
