1. Manually turn on the CABLE box.
2. Locate the enclosed CABLE box Code List.
Find your brand in the CABLE box Codes.
Note: If your brand isn’t listed, use one
of the Code Search methods to program
this remote control. (See section on
Code Search on page 10).
3. Press and hold the CODE SEARCH key
until the indicator light illuminates.
Then release the CODE SEARCH key.
4. Press and release the CABLE key. The
indicator light blinks and then remains lit.
5. Use the number keys on the remote to
enter the first code listed for your
brand. After you enter a valid three-
digit code, the indicator light turns off.
Note: If you enter an invalid code, the
LED flashes rapidly for two seconds.
Start over at step 3.
6. Aim the remote at the CABLE box. Press
the ON•OFF key. If your CABLE box
turns off, you have found the correct code.
7. Enter the code in the box provided on
this page for future reference.
8. If your CABLE box does not turn off,
repeat steps 3-6 above, entering the next
code for your brand.
If none of the codes work or your brand
is not listed, use one of the Code Search
methods to program this remote.
(See Code Search section on page 10).
Program for Cable Box—Direct Entry Method
In order for the six-component universal remote to control your CABLE box,
you must program it with the code that matches your CABLE box.
To program your remote to control your CABLE box, follow these steps:
8
This remote control will operate many features found in AUDIO systems. To
program your remote to control your audio component, follow these steps:
Note: CD systems need to be
programmed using the DVD
component key.
1. Manually turn on the AUDIO
component you wish to control.
2. Locate the enclosed AUDIO system Code
List. Find your brand in the AUDIO Codes.
Note: If your brand isn’t listed, use one
of the Code Search methods to program
this remote control. (See section on
Code Search on page 10).
3. Press and hold the CODE SEARCH key
until the indicator light illuminates.
Then release the CODE SEARCH key.
4. Press and release the AUDIO key. The
indicator light blinks and then remains lit.
5. Use the number keys on the remote
to enter the first code listed for your
brand. After you enter a valid three-
digit code, the indicator light turns off.
Note: If you enter an invalid code, the
LED flashes rapidly for two seconds.
Start over at step 3.
(BLINK)
CABLE BOX CODE
(BLINK)
CODE
SEARCH
INDICATOR
LIGHT
CODE
SEARCH
INDICATOR
LIGHT
(OFF)
(OFF)
ON•OFF
CABLE
AUDIO
Program for AUDIO Systems—
Direct Entry Method
To Next Page
Loading...
Need help?
General
