RCA RP5610 User Manual

EN
EN
5
Operating the CD player
Listening to compact disc
1. Lift to open the CD compartment door.
2. Insert a disc and close the door.
3. Press PLAY/PAUSE
.
4. Adjust volume to your desired level.
5. Press REV
or FWD to skip back-
ward and forward.
6. Press STOP  to stop CD playback.
Selecting play mode
1. Start CD playback.
2. During playback, press CD MODE to
toggle between different play modes.
REPEAT ONE
- repeat the current track.
REPEAT ALL
- repeat the whole disc.
SHUFFLE
- play tracks randomly.
SHUFFLE REPEAT
- play random
tracks repeatedly.
4
Operating the Radio
Tuning the Stations
1. Press ON to turn on the radio.
2. Slide the FM/AM switch to the desired
broadcast band.
3. Turn the TUNING knob to select a
station.
4. Press OFF to turn off the radio.
Built-In AFC
The Built In Automatic Frequency Control
(AFC) works only on FM. It helps reducing
drift on FM reception and keeping the
radio locked in on the FM station to which
it is tuned.
When tuning in FM stations, you may
notice that the station you are tuning can
be well-tuned on two or three nearby
points on the dial. Always tune carefully
at the loudest and clearest point.
Antennas
AM Antenna - A built-in ferrite rod
antenna eliminates the need for an out-
side antenna for AM reception. Rotating
the unit slightly may improve the recep-
tion of distant AM stations.
FM antenna - The power cord acts as your
FM antenna. It picks up moderate to
strong stations and eliminates the need for
an external antenna in most strong signal
areas. Be sure the power cord is stretched
to its full length. Do not coil or bunch the
cord together. Changing position of the
power cord may improve reception.
AM
FM
TUNING
AM/FM
Tip:Tip:
Tip:Tip:
Tip:
You may try to move the power
cord in order to improve the re-
ception.
Note:Note:
Note:Note:
Note:
When there is no disc in the
CD compartment, “nd” will
show on display.
Listening to auxiliary source
1. Connect the external auxiliary source
(e.g. mp3 player) to AUX IN jack on the
left of the unit with an audio cable.
2. Press ON twice to select auxililary input
mode with AUX shows on the display.
3. Adjust volume by rotating the volume
control knob. Control other playback op-
erations on the auxiliary unit.
RP5610_EN(US) 4/10/06, 2:14 PM6-7

RCA RP5610 Specifications

Power

AC power	120 V / 50-60Hz
DC battery back-up	Yes

Ports & Interfaces

auxiliary input	Yes

Weight and Dimensions

product dimensions	6.46 x 3.43 x 6.93 inches
carton dimensions	8.35 x 8.98 x 4.72 inches
master pack dimensions	8.5 x 9 x 14.2 inches
product weight	2.84 lbs
carton weight	3.54 lbs
master pack weight	10.67 lbs