÷
CD Lens Care
When your CD lens gets dirty it can also cause the
system to output poor sound quality. To clean the lens
you will need to purchase a CD lens cleaner which can
maintain the output sound quality of your system. For
instructions on cleaning the CD lens, refer to the ones
accompanying the lens cleaner.
Tape Player
• To prevent deterioration of
sound quality, periodically _ _
open the door of each deck
and clean the magnetic heads,
pinch roller, and capstan with
a cotton bud dipped in alcohol.
• Also, demagnetize the head by playing a
demagnetizing cassette (available through an audio
equipment store).
• To protect your recordings from accidental erasure on
one or both sides of your cassette, snap out the tab at
the top of the cassette. If you decide
later to record on the tape, seal the _ _1_
hole with a piece of adhesive tape.
(Refer to diagram on the right)
• Ouit Slacking - A little bit of slack in your tapes can
cause scratches on the tape, or worse yet,
the tape could break. If you notice some
slack in the tape, use a pencil to tighten it
up before you insert it.
Important Batteries
Information
• Remove the batteries to avoid leakage if you do not
use your remote control for more than one month.
Discard leaky batteries immediately as leaking batteries
may cause skin burns or other personal injuries. Dispose
of batteries in the proper manner, according to
provincial and local regulations. Any battery may leak
electrolyte if mixed with a different battery type, if
inserted incorrectly, if all batteries are not replaced at
the same time, if disposed of in fire, or if an attempt is
made to charge a battery not intended to be recharged.
Headset Safety
• Do not play your headset at high volume. Hearing
experts warn against extended high volume play.
• If you experience ringing in your ears, reduce volume
or discontinue use.
• You should use with extreme caution or temporarily
discontinue use in potentially hazardous situations. Even
if you headset is open-air designed to let you hear
outside sounds, do not turn up the volume so high that
you are unable to hear what is around you.
Information labels
They are placed behind and inside the set.
Safety Precautions
• Never open the cabinet under any circumstances. Any
repairs or internal adjustments should be made only by a
trained technician.
• Never operate this product with the cabinet removed.
• Do not touch the player with wet hands. If any liquid
enters the player cabinet, take the player to a trained
technician for inspection.
• This compact disc player uses a laser to read the music
on the disc. The laser mechanism corresponds to the
cartridge and stylus of a record player. Although this
product incorporates a laser pick-up lens, it is completely
safe when operated according to directions.
• Discs rotate at high speed inside the player. Do not
use damaged, warped, or cracked discs.
• Prevent damage to this product, set switch for proper
voltage.
• Do not touch the pick-up lens which is located inside
the disc compartment. Also, to keep dust from
collecting on the pick-up lens and do not leave the
compartment door open for an extended period of time.
If the lens becomes dirty, clean it with a soft brush, or
use an air blower brush designed for camera lenses.
• Do not expose this appliance to rain or moisture.
Technical Specifications
Power supply: 120V-60Hz
Speaker impedance: 8 ohm
Phone impedance: 32 ohm
Dimensions (mm): W: 440 - H: 230 - D: 220
Tape deck: Response curve: 125Hz-8kHz (-5dB)
CD player: Response curve (+/- 2dB): 20Hz to 20
kHz
• Rating Plate: Look for it at the back of the set.
The descriptions and characteristics in this owner's manual are for the
purpose of general reference only and not as a guarantee. In order to
provide you with the highest quality product, we may make changes
or modifications without prior notice. The English version serves as the
final reference on all product and operational details should any
discrepancies arise in other languages.
_8
÷
RS1290EN rev.2 12 _ 5/3/01, 10:45 AM
To Next Page
Loading...
Need help?
General
