9
EN
Radio
1. Press SOURCE to select TUNER.
2. Press BAND to select between AM or FM radio
band.
Tuning to a Station
Press SKIP FORWARD / BACKWARD
to select frequencies.
Using Presets
The tuner can be in either
TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
Press SKIP BACKWARD or SKIP FOR-
WARD on the main system or PRESET UP or
DOWN on the remote control to access the previous
or next preset station. The display first shows the pre-
set program number and after a few seconds, the fre-
quency and preset program number will be displayed.
(FMPR:01 is FM preset 1)
Auto Preset
Programming
(for FM only)
Press and hold BAND
button for 2 seconds to scan stations in FM band. The
stations will then be stored as preset channels. A maxi-
mum 32 stations can be stored. Beware of your preset
channels being erased accidentally because the scan-
ning and storing process is automatic upon pressing
the button. You can stop the automatic scan by press-
ing any button, but the erased stations cannot be
recovered.
Setting Presets
1. Press TUNE/PRESET button to enter TUNER mode.
2. Press SKIP FORWARD / BACKWARD
to access the desired frequency.
3. Press the PROG/SET button once.
4. The most recently accessed program location will
be displayed.
5. If a different program location is preferred, press
SKIP BACKWARD / FORWARD to
move to the desired preset number (1-32).
6. Press PROG/SET to store the selected frequency at
that preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and stereo
for stereo FM stations. (Remote Only)
PR:01
87.50 MHz
SURR.
To Next Page
Loading...
Need help?
General
