FCC Information

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two

conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any

interference received, including interference that

may cause undesired operation.

In accordance with FCC requirements, changes or

modifications not expressly approved by Thomson

Inc. could void the user’s authority to operate this

product.

This device generates and uses radio frequency

(RF) energy, and if not installed and used

properly, this equipment may cause interference

to radio and television reception.

If this equipment does cause interference to radio

or television reception (which you can determine

by unplugging the unit), try to correct the

interference by one or more of the following

measures:

• Re-orient the receiving antenna (that is, the

antenna for the radio or television that is "

receiving" the interference).

• Move the unit away from the equipment that is

receiving interference.

• Plug the unit into a different wall outlet so

that the unit and the equipment receiving

interference are on different branch circuits.

If these measures do not eliminate the

interference, please consult your dealer or an

experienced radio/television technician for

additional suggestions. Also, the Federal

Communications Commission has prepared a

helpful booklet, "How To Identify and Resolve

Radio TV Interference Problems." This booklet

is available from the U.S. Government Printing

Office, Washington, DC 20402. Please specify

stock number 004-000-00345-4 when ordering

copies.

This product complies with DHHS Rules 21 CFR

Subchapter J. Applicable at the date of

manufacture.

For Your Safety

The AC power plug is

polarized (one blade is wider

than the other) and only fits

into AC power outlets one

way. If the plug won’t go into

the outlet completely, turn the

plug over and try to insert it the other way. If it

still won’t fit, contact a qualified electrician to

change the outlet, or use a different one. Do not

attempt to bypass this safety feature.

CAUTION: TO PREVENT ELECTRIC SHOCK,

MATCH WIDE BLADE OF PLUG TO WIDE SLOT,

FULLY INSERT.

Main plug is used as the disconnect device, it shall

remain operable and should not be obstructed

during intended used. To be completely

disconnected the apparatus from supply mains,

the main plug of the apparatus shall be

disconnected from the mains socket outlet

completely.

RECORD

Have a Blast- Just Not in Your

Eardrums

Make sure you turn down the

volume on the unit before you

put on headphones. Increase

the volume to the desired level

only after headphones are in

place.

RCA RS2657

Table of Contents

Other manuals for RCA RS2657

Related product manuals