Operating Your Receiver
EN
13
Operating Your Receiver
• Audio output is in Dolby Digital mode.
• Audio output is in Dolby ProLogic mode.
• Audio output is in 3 Stereo mode.
• Tuner stereo signal detected.
• Tuner station detected.
• Unit is in DSP (Digital Sound Processing) mode.
• Speaker Icons.
• Unit in Sleep mode.
• Unit in Memory mode.
• Tuner frequency unit.
DSP
ST
TUNED
SLEEP
MEMORY
KHz
MHz
Switching on /off
• To switch on the receiver, press STANDBY/ON but-
ton (1) once. Alternatively, you can press any of the
source buttons to power on the receiver.
• Standby: when the receiver is on, press the
STANDBY/ON button once to activate the standby
mode.
• To switch off the unit completely, unplug the
power cord from the socket
Selection of Audio/Video source
When one of the source button is pressed, the audio
and video input corresponding to the name will be
activated.
The receiver acts as a switching device between all
the sources that are plugged into to it.
Example 1:
If you connect a DVD player to the DVD input
(audio + video) on the receiver and press the DVD
button, you will be able to have the sound and
image transmitted by the DVD.
Example 2:
Based on the example 1, the DVD is playing , if a
VCR is connected to the VCR 1 input (audio +
video) of the receiver and the VCR1 button is
pressed, image and sound from the VCR source will
replace the DVD.
NOTE
Your receiver has a back up memory to keep
your settings like preset radio station for
about 2 weeks in case electricity cut occurs. If
the receiver is unplugged for more than 2
weeks, all the settings will be lost and re-set-
ting will be necessary.
To Next Page
Loading...
Need help?
General
