RCA STA-3850 - User Manual

Questions and Answers

G
gravesmaryJul 30, 2025
What to do if my RCA Stereo Receiver remote control does not work?
- S
  Savannah WardJul 30, 2025
  If your RCA Stereo Receiver's remote control isn't working, start by installing fresh batteries. Ensure you're using the remote within its effective range and at a proper angle to the remote sensor window. Check for any obstacles blocking the path between you and the remote sensor window and remove them. Finally, check if a fluorescent light is shining on the remote sensor window and turn off the light.
I
iweberAug 5, 2025
Why is there no sound coming from my RCA STA-3850 Stereo Receiver?
- A
  Anthony OrtegaAug 6, 2025
  Several factors could cause a lack of sound from your RCA Stereo Receiver. Check the connections to ensure they are correct. Make sure the mute function is not activated by pressing the MUTING button. Verify the volume isn't turned down and increase it as needed. Ensure speaker wires are properly connected and that the correct set of speakers (A or B) is selected. If only one set of speakers is connected, ensure that only one of the SPEAKERS A or B buttons is active. Lastly, confirm that the TAPE MONITOR function is off by pressing the TAPE MONITOR button.
J
judithmooreAug 11, 2025
Why is the sound only coming from one speaker on my RCA STA-3850?
- E
  emmawolfAug 11, 2025
  If you're only getting sound from one speaker on your RCA Stereo Receiver, check all speaker wires and input cords to ensure they are properly connected. Also, verify that the BALANCE setting is set to the center position.
D
Donna MayAug 17, 2025
Why is there a high noise level coming from my RCA STA-3850 Stereo Receiver?
- J
  Jesse SanchezAug 17, 2025
  A high noise level from your RCA Stereo Receiver can be due to several reasons. First, adjust the tuning to ensure you're correctly tuned to the station. Check that the antenna is connected properly. If using the FM antenna, stretch both ends taut and reposition it. For AM, adjust the AM loop antenna. If the noise persists, it might be coming from another electrical appliance; try using an AC line noise filter.
X
xsimpsonAug 23, 2025
What to do if automatic tuning does not stop when searching for stations on my RCA Stereo Receiver?
- Y
  ywalkerAug 23, 2025
  If the automatic tuning on your RCA Stereo Receiver doesn't stop when searching for stations, it could be due to weak signals. Try using a better antenna to improve reception.