Restoring the Default Settings
This feature will reset the phone settings back to the original factory defaults
NOTE: This will erase records in call history and phone book.
1. Press the “ Menu ” softkey while in idle mode.
2. Using the directional pad, move the indicator to “ Factory Reset .” Press the “ Select ” softkey.
3. Move the indicator to “ Yes ” and press the “ Select ” softkey. Confirm the action once more and the phone
will reboot with the default settings.
Basic Operation
Your phone provides the convenience of four separate telephone lines, each with its own phone number. It
can have up to ten telephones or cordless handsets sharing multiple lines. Each station is connected to all
others via intercom.
Making Calls with the Handset
1. Pick up the handset and the phone automatically selects the priority line. If the priority line is in use, it will
select the next open line or you may select a line by pressing the corresponding line key.
2. Wait for the dial tone, then dial a phone number.
3. Hang up the handset when finished.
Making Calls with the Speakerphone
1. Press the Speakerphone button and the phone automatically selects the priority line. If the priority line is
in use, it will select the next open line or you may select a line by pressing the corresponding line key.
2. Wait for the dial tone, then dial a phone number.
3. Press the Speakerphone button when finished.
Making Calls with the Optional Headset
1. Connect the headset plug into the headset jack on the right side of the base.
2. Adjust the headset so the microphone is approximately 2 to 3 inches away from your mouth.
3. Press the Headset button and the phone automatically selects the priority line. If the priority line is in use,
it will select the next open line or you may select a line by pressing the corresponding line key.
4. Wait for the dial tone, then dial a phone number.
5. Press the Headset button when finished.
NOTE: The Unison system will work with most tele
com headsets that have a 2.5mm headset jack.
Pre-dialing
1. With the phone idle and the handset in the cradle, manually enter the telephone number. The number will
show in the display.
2. Press the “ Dial ” softkey, press the Speaker button or lift the handset to take a line and the number will
automatically be dialed. Press the “ Clear ” softkey to delete the previous digit and the “ Home ” softkey to
13
cancel the call before dialing.
To Next Page
Loading...
Need help?
General
