First Things First
4
Step 1: Unpack What’s in the Box
The following items come packed in the box:
• VCR
• Remote control
• RF antenna cable
STEP 2: Install Batteries In the
Remote Control
Follow these steps whenever you need to install or change the
batteries in your VCR remote.
1. Remove the cover of the battery compartment.
2. Place batteries in remote, matching the + and – ends of each
battery to the diagram inside the compartment.
3. Replace the cover.
STEP 3: Connect your vcr
If you connect your VCR to your home antenna or cable system
and then to your TV, use the VCR’s IN FROM ANTENNA and OUT
TO TV jacks for a good signal as shown.
If you have a TV with AUDIO/VIDEO jacks, use these jacks for a
better connection. In order to hear stereo and hi-fi sound from
the VCR, the audio/video jacks must be used. Refer to the
Connections section, toward the back of the manual.
STEP 4: PLUG IN THE VCR
Match the wide blade of the plug with the wide slot in the
outlet. Be sure to insert the plug completely.
VCR
TV
CABLE/
ANTENNA
CABLE, CABLE BOX, OR ANTENNA
3 CH. 4
IN FROM
ANT.
VIDEO
OUT
R-AUDIO-L
OUT TO TV
VHF/UHF
MONO
IN 1
To Next Page
Loading...
Need help?
General
