26
RECORDING
Timer Recording with VCR Plus+
You can use VCR Plus+ to simplify timer programming if you have
cable TV and don’t receive all channels through a cable box or if
you receive your TV signal off-air.
Setting Up the Channel List
If you did not set up the VCR Plus+ channel list, you can do it now.
1. Display the CHANNELS menu from the VCR MAIN MENU.
2. Display the VCR Plus+ Channel List menu.
3. Go to Setting Up Your VCR if you need more information on
setting up your VCR Plus+ channel list.
Using VCR Plus+
1. Press MENU to bring up the VCR MAIN MENU.
2. Press 1 to display the VCR PLUS+ menu.
VCR MAIN MENU
1 VCR Plus+
2 Timer Recordings
3 Time
4 Channels
5 Preferences
6 Audio
7 Language
0 Exit
6. Review the information to make sure it is correct, and then
press MENU to save.
1 (one time)
Program 1 has been saved
Remember to insert a
recordable tape and
turn the VCR off before
the program start time.
Press MENU to continue
VCR MAIN MENU
1 VCR Plus+
2 Timer Recordings
3 Time
4 Channels
5 Preferences
6 Audio
7 Language
0 Exit
VCR PLUS+
Enter PlusCode Number
(from TV listing)
_
Press MENU to cancel
VCR Plus+ and PlusCode are registered trademarks
of Gemstar Development Corporation.
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type: CABLE
4 VCR Plus+ Channel List
0 Exit
VCR+ Channel My Channel
5 46
4 --
3 -> -> -> 23
2 --
1 --
Use CH+/- to select
Press 0-9 to change
Press MENU to save
If you receive all channels through your
cable box on Channel 3 or 4, you must
use the regular Timer Recording method
to record programs.
To Next Page
Loading...
